How to Accurately Use a Torque Wrench with a Crowfoot Wrench

When you connect a torque wrench with another tool, like a crowfoot wrench, it's important to pay attention to how the two tools are configured. You could be applying more or less torque than you intended to, depending on how the tools are working together.

If you place the crowfoot wrench at an angle 90-degrees to the torque wrench handle, the amount of torque you’re applying doesn’t change. You can set the torque wrench to the fastener’s torque specification and continue to use the torque wrench normally. This is because the center of the fastener remains on the same plane as it was before you added the crowfoot wrench, meaning that the overall effective length of the torque wrench stays the same.

Sometimes it’s not possible or desirable to work with your crowfoot wrench at a 90-degree angle to the wrench handle. In situations like this, you can still accurately measure torque. In fact, if you do a calculation based on the new total length of the torque wrench and crowfoot wrench combined, you‘ll be able to accurately measure torque with the crowfoot wrench in any position.

Use the torque conversion calculator provided below to adjust for using the crowfoot wrench at any angle. Please note that it’s always important to use proper technique in order to get accurate results with your torque wrench.


Torque Conversion Calculator



 
 
in.
 
ft.-lb.
(Set your torque wrench to this)




Formula Inputs

T1Torque specification for the fastener.

LEffective length of the torque wrench. Measure from the center of the square drive tang to the groove in the knurled handle grip on Tekton torque wrenches (check manufacturer recommendations for other brands of torque wrenches and use the center of the handle grip if the manufacturer does not recommend a location). First, set the torque wrench to the torque spec for the fastener (T1) and then measure in a straight line parallel to the body of the wrench.

CChange in length caused by the crowfoot wrench. Measure from the center of the fastener to the center of the square drive tang on the torque wrench. Measure in a line parallel to the body of the wrench. If the position of the crowfoot wrench decreases the effective length of the torque wrench, creating a negative change, then input this amount into the equation as a negative number.

Formula Output

T2Final torque wrench setting that you should use. This will correct for any change in leverage caused by using the crowfoot wrench.


TERMS OF USE:
By using the Torque Conversion Calculator, you agree that you alone are responsible for the conversion calculation, torque wrench setting, and any actual application of the conversion calculation.

Featured Tools


3/8 Inch Drive Click Torque Wrench (10-80 ft.-lb.)
3/8 Inch Drive Crowfoot Wrench Set, 30-Piece (Rack)
3/8 Inch Drive Crowfoot Wrench Set, 30-Piece (Key)