Molded Handle Bit Driver and Insert Bit Set with Case (38-Piece)
P1 - P3 
3/16 - 5/16 in. 
T7 - T30 
5/64 - 1/4 in., 2 - 6 mm 
S1 - S3 P1 - P3 3/16 - 5/16 in. T7 - T30 5/64 - 1/4 in., 2 - 6 mm S1 - S3 Set Includes:
- Phillips, Slotted, Square Insert Bit Set (1.18 Inch Length) with Rail (9-Piece)
-
Phillips: P1, P2, P3 (3 sizes)
-
Slotted: 3/16, 1/4, 5/16 in. (3 sizes)
-
Square: S1, S2, S3 (3 sizes)
- Hex Insert Bit Set (1.18 Inch Length) with Rail (9-Piece)
-
Hex: 5/64, 3/32, 7/64, 1/8, 9/64, 5/32, 3/16, 7/32, 1/4 in. (9 sizes)
- Hex Insert Bit Set (1.18 Inch Length) with Rail (9-Piece)
-
Hex: 2, 2.5, 3, 3.5, 4, 4.5, 5, 5.5, 6 mm (9 sizes)
- Star Insert Bit Set (1.18 Inch Length) with Rail (9-Piece)
-
Star: T7, T8, T9, T10, T15, T20, T25, T27, T30 (9 sizes)
- 1/4 Inch Hex Shank x 2 Inch Magnetic Bit Holder Extension
- 1/4 Inch Molded Handle Magnetic Bit Driver
- Case with Foam
Details
Video Overview
Bits with Rails
Slightly Longer than Typical Insert Bits
Low Shoulders for Recessed Screws
For small tip sizes, the shoulders on the hex shank are reduced as low as possible, keeping the shaft diameter narrow so it can reach into tight, recessed areas.
Hardened Steel with Precise Tip Geometry
The bits are made of S2 tool steel and are through-hardened to 58 - 61 HRC. Tight tolerances on the tip geometry keep the bit seated in the screw, reducing slip and wear.
Stamped Markings and Satin Finish
The tip size is permanently stamped onto every bit in large, clear type. A zinc-phosphate coating adds a satin finish that resists corrosion.
Free-Standing Bit Rails
The flexible rails securely grip the bits so they can’t fall out, while also making it easy to remove any bit one-handed. The rails can also stand upright on a surface.
Sizes are printed on the rails for easy identification
Magnetic Bit Driver with Molded Handle
Soft Overmold Grip with Flared End for Controlled Spinning
The handle’s red exterior is made of a lightly textured TPE material that is slightly soft and grippy for controlled spinning. The handle materials resist most common shop chemicals.
The front end of the handle has a tri-lobe shape that flares out to prevent your hand from slipping while you’re pushing it forward and turning.
Magnetic Bit Holder
Bits are held securely by a magnet that is permanently press-fit and cannot come out.
3.2 Inch Blade Length
Compact Carrying Case
Specifications
1/4 Inch Molded Handle Bit Driver and Insert Bit Set with Case (38-Piece)
| Country of Origin | Bits, bit rails, magnetic bit extension, case, and bit driver blade made in Taiwan. Bit driver handle made in Germany. |
| Item Weight | 0.95 lb. |