New
TEKTON Star Insert Bit Set (1.18 Inch Length) with Rail, 12-Piece (T6 - T45) - 1/4 in. Hex Shank
Back angle view of Tekton rail bit set. Item #DZT93003
Laid out contents of Tekton rail bit set. Item #DZT93003
Side view of Tekton rail bit set. Item #DZT93003
Person holding Tekton rail bit set. Item #DZT93003
Tap image to zoom in
Item #DZT93003
1/4 Inch Hex Shank
1.18 Inch Bit Length

Star Insert Bit Set with Rail (12-Piece)

Star T6 - T45
•

Set Range

T6 - T45
$8
T7 - T30
$7
$8.00
Add to Cart

Also Available In:

0.75 Inch Length

Tamper Star

Set Includes:
DetailsSpecifications

Details

Video Overview

  • 1.18 Inch Length - Slightly longer than typical insert bits
  • Low Shoulders - Access screws in tight, recessed areas
  • Precise Tip Geometry - Secure fit in screws, reducing slip and wear
  • S2 Steel - Through-hardened to 58 - 61 HRC
  • Stamped Markings - Clear, permanent size markings
  • Zinc-Phosphate Coating - Resists corrosion
A typical 0.98 inch Phillips bit next to a Tekton 1.18 inch Phillips bit #DZC30012

Slightly Longer than Typical Insert Bits

A graphic showing a slotted bit turning a recessed slotted screw.

Low Shoulders for Recessed Screws


For small tip sizes, the shoulders on the hex shank are reduced as low as possible, keeping the shaft diameter narrow so it can reach into tight, recessed areas.


Close-up image of the tip of a star bit.

Hardened Steel with Precise Tip Geometry


The bits are made of S2 tool steel and are through-hardened to 58 - 61 HRC. Tight tolerances on the tip geometry keep the bit seated in the screw, reducing slip and wear.


A 4 mm hex bit being removed from a rail.

Stamped Markings and Satin Finish


The tip size is permanently stamped onto every bit in large, clear type. A zinc-phosphate coating adds a satin finish that resists corrosion.

Free-Standing Bit Rail


The flexible rail securely grips the bits so they can’t fall out, while also making it easy to remove any bit one-handed. The rail can also stand upright on a surface.


Sizes are printed on the rails for easy identification

Sizes are printed on the rail for easy identification

A bit being removed from the rail. Set #DZZ93005 is shown.

Specifications

Star Insert Bit Set (1.18 Inch Length) with Rail, 12-Piece (T6 - T45) - 1/4 in. Hex Shank

Specs for Star Insert Bit Set (1.18 Inch Length) with Rail, 12-Piece (T6 - T45) - 1/4 in. Hex Shank
Country of Origin
Taiwan
Item Weight
0.16 lb.