1/2 Inch Drive Deep 6-Point Socket Sets (3/8 - 1-5/16 in., 10-32 mm)

Item #SHD92005
Ships tomorrow
$75.00

Large, Stamped Markings

  • Permanently impressed into the material by a roll-stamp die
  • As large as possible while still being readable along the socket’s curved surface
  • Clearly visible size numbers with extra-deep outline

Fully Stepped Shoulders

Narrowed diameter stretches to the base of the socket on small, deep-length sizes. This provides greater reach into tight, recessed areas.


Exterior + Interior Finishes

  • Chrome-plated exterior is highly corrosion resistant and wipes clean to a mirror finish
  • Interior is protected against rust with clear coat, rather than commonly-used metallic paint

6-Point Socket Opening

Provides an exact fit and maximum contact for hex fasteners

Prevents Fastener Round-Off

Radiused corners prevent fastener round-off by applying force to a fastener’s flat sides, rather than its corners.

Secure Drive Tool Engagement

  • Four detent grooves provide a secure connection with the retaining ball of a drive tool
  • Beveled inner rims help guide the socket onto other tools

High Torque Strength

Meets minimum value of 1.2 times the ANSI standard for Proof Torque. Verified by a single-cycle test that applies torque until specified value is reached without failure or permanent deformation.

METRIC SERIES

ANSITEKTON
Source: ASME B107.5M - 2002

INCH SERIES

ANSITEKTON
Source: ASME B107.1 - 2002

Socket Rail Storage

1/2 Inch Drive Deep 6-Point Socket Set, 16-Piece (3/8 - 1-5/16 in.) - Rails

A. Length 3.0 in.
B. Socket End Diameter 0.57 in.
C. Drive End Diameter 0.87 in.
D. Socket Opening Size 3/8 in.
E. Drive Size 1/2 in.
F. Well Depth 1.0 in.
Weight 0.25 lb.
Country of Origin Taiwan