1/4 Inch Drive Socket and Ratchet Sets (5/32-9/16 in., 4-14 mm)
Large, Stamped Markings
- Permanently impressed into the material by a roll-stamp die
- As large as possible while still being readable along the socket’s curved surface
- Clearly visible size numbers with extra-deep outline
Fully Stepped Shoulders
Narrowed diameter stretches to the base of the socket on small, deep-length sizes. This provides greater reach into tight, recessed areas.
Exterior + Interior Finishes
- Chrome-plated exterior is highly corrosion resistant and wipes clean to a mirror finish
- Interior is protected against rust with clear coat, rather than commonly-used metallic paint
6-Point Socket Opening
Provides an exact fit and maximum contact for hex fasteners
Prevents Fastener Round-Off
Radiused corners prevent fastener round-off by applying force to a fastener’s flat sides, rather than its corners.
Secure Drive Tool Engagement
- Four detent grooves provide a secure connection with the retaining ball of a drive tool
- Beveled inner rims help guide the socket onto other tools
High Torque Strength
Meets minimum value of 1.2 times the ANSI standard for Proof Torque. Verified by a single-cycle test that applies torque until specified value is reached without failure or permanent deformation.
|Source: ASME B107.5M - 2002|
|Source: ASME B107.1 - 2002|
- 4-degree swing arc
- Ultra-compact head is reduced in all dimensions
- Quick-release drive locks sockets onto tang and releases with the press of a button
3 and 6 Inch Extensions
Reach past obstructions and into tight spaces. Knurled band provides grip for starting or turning loosened fasteners.
Pin-style joints rotate smoothly and continuously to access fasteners at up to 55-degree angles.
Use the sockets like a nut driver with the spinner handle, adding a ratchet to the end for extra leverage.
Hex Bit Holder
Quickly change out and adapt any 1/4 inch hex shank bit to 1/4 inch drive tools.
- Resilient high-density polyethylene material withstands exposure to common lubricants, fuels, and solvents
- Strong latches, and hinges with metal pins
- Molded size markings for each tool inside the case
1/4 Inch Drive 6-Point Socket and Ratchet Set, 33-Piece (4-14 mm)
|A. Length||10.7 in.|
|B. Width||6.6 in.|
|C. Height||2.4 in.|
|Country of Origin||Taiwan|