1/2 Inch Drive 3/4 x 13/16 Inch Thin Wall Impact Flip Socket
Details
Ideal for Wheel Service
Maximum Reach
Maximum Reach
The Tekton flip socket is both longer and has lower stepped shoulders than competitors to give you maximum reach into lug nut wells.
Thin Walls
The outer diameter is 1 to 2 mm smaller than other Tekton impact sockets, allowing for better access in tight lug nut wells.
Radiused Corners
The radiused corners prevent fastener round-off by applying force to the flat sides of a lug nut, rather than its corners.
60° Chamfer
The steep 60° chamfered opening makes it easy for the flip socket to slide over lug nuts.
Extra Deep Wells
Each socket well is extra deep to provide increased engagement with lug nuts and clearance for decorative caps.
- The extra long socket allows each well to be deeper for greater engagement
- The extension is recessed to avoid contact with decorative caps
Laser & Stamped Markings
The size is marked in two ways on every socket—both as a high-visibility laser marking and a permanent stamped marking.
Sockets Exceed ANSI Torque Standards
Each flip socket size meets a minimum of 1.3 times the ANSI/ASME standard for proof torque.
(A single-cycle test applies torque until a specified value is reached without failure or permanent deformation.)
INCH SERIES
| ANSI | TEKTON | ||
| Source: ASME B107.110-2012 | |||
METRIC SERIES
| ANSI | TEKTON | ||
| Source: ASME B107.110-2012 | |||
High-Performing Steel Alloys
High-Performing Steel Alloys
The flip sockets are made from 4140 Chromium-Molybdenum steel
All pieces have a corrosion-resistant manganese phosphate coating.
Specs
1/2 Inch Drive 3/4 x 13/16 Inch Thin Wall Impact Flip Socket
| Country of Origin | Taiwan |
| Item Weight | 0.36 lb. |