3/4 Inch Drive x 34 mm 6-Point Socket
Prevents Fastener Round-Off
The socket opening is designed with radiused corners in order to contact fasteners on their flat sides and not their corners, preventing round-off.
Exact Fit for Hex Fasteners
A 6-point socket opening is ideal for hex-shaped fastener heads because it contacts the most surface area of the steel. This exact fit makes the tool less likely to slip or fail, especially when you’re applying a lot of force or working with damaged or rusted fasteners.
Large, Stamped Markings
Permanently Impressed into the steel by a roll-stamping die and can't wear off
As large as possible while still being readable along the socket's curved surface
Clear even in low light settings with an extra-deep outline around the size numbers
The polished chrome plating protects against corrosion and wipes clean to a mirror finish.
To prevent rust in the socket wells, we added a layer of clear coat, rather than conventionally used silver paint.
Secure Drive Tool Engagement
A. Four detent grooves provide a secure connection with the retaining ball of a drive tool.
B. Drilled through-hole allows ability to lock sockets onto a drive tang with a retaining pin.
C. Beveled edge helps guide a drive tang smoothly onto the socket.
D. Radiused corners reinforce the strength of the drive end by eliminating sharp angles that are prone to cracking under stress.
High Torque Strength
Our 3/4 inch drive sockets meet a minimum value of 1.3 times the ANSI standard for Proof Torque—a measure of strength verified by a single-cycle test that applies torque until the specified value is reached without failure or any permanent deformation.
Most Complete 3/4 Inch Hand Drive Socket Line
Competitor totals based on available items in online catalogs as of Jan 16, 2019.
Please select all item options to see specs